top of page
  • Writer's

How to care for your swimming pool in winter

The harsh elements of winter can really take their toll on different parts of the home and the backyard pool is no exception.

If you’re planning to switch off pool equipment during winter to save money on electricity and chemical costs, think again.

Not only will you run the risk of damaging expensive filtration and sanitation systems but you could also damage your pool’s design.

Chris Fitzmaurice, of pool and spa specialists Swimart, says regular pool maintenance will ensure everything is looking good and operating well, saving you a bigger and potentially costly job later on.

Check Chris’ 10 tips for keeping home swimming pools in tip-top condition as the weather cools:

1. Clean the pool

Brushing the walls and floor, and then vacuuming the whole pool every couple of weeks helps prevent icky algae from forming. Clean the skimmer baskets and the pump’s lint basket of leaves to also ensure the filtration system works efficiently.

2. Balance pool water

The pool’s pH level needs to be between 7.2 and 7.6, which you can easily check by taking a water sample from elbow deep and adding the appropriate treatment to bring the pool to the correct level.

3. Clean the filter

Ensure that the pool’s filter is regularly cleaned, as any grease or oil deposits will harden over winter and make the filter even harder to clean in the warmer months.

4. Check chlorine levels

To keep your pool clean and clear, it’s important to maintain your pool’s free available chlorine at a constant level of 2-3 parts per million (PPM) throughout winter. If you’re using a salt chlorinator and a pool blanket, remember to reduce the output of the chlorinator to 1-2 PPM, as pool blankets trap chemicals and chlorine, and can cause high chlorine levels to occur – potentially damaging pool equipment if not monitored carefully.

5. Use a shock treatment

Regularly ‘shocking‘ your pool helps remove organic and inorganic wastes (referred to as chloramines), which includes sweat, suncream, bird droppings and dead bugs.

It also ensures that the sanitiser can concentrate on killing bacteria and algae instead of these contaminants. Once you’ve added the shock treatment appropriate for your pool, run both the pump and filter for several hours to ensure it has been evenly distributed throughout the pool.

6. Remove algae as soon as you see it

When there is an algal bloom, most of the sanitiser in your pool is used trying to control and kill the algae, leaving no residual to keep pool water clean and healthy.

7. Reduce filter-running times

The pool’s filter should operate three to four hours each day during winter. If you’re using a timer, adjust it to suit. You can save money by switching the filter on during off-peak periods.

8. Set your solar heater to ‘Winter Mode’

If you don’t have an automatic controller on your solar pool heating system, manually switch it to Winter Mode or switch it off completely if you’re heading out of town.

9. Use your pool cover

Roll out the pool cover when you’re not using the pool to help keep leaves and other organic material out of the water. This means less cleaning for you and less food for algae and bugs to feed on – win, win! Pool covers and blankets also help minimise chemical evaporation – saving you time and money.

10. Keep up your maintenance schedule

Once you’ve done the full winter prep as outlined above, it’s important that you keep to a weekly maintenance schedule even when you’re not using the pool.

This involves doing a visual inspection to make sure all of your equipment is working properly, checking the water level and topping up if necessary, emptying the skimmer basket, and checking your chlorine and pH levels.

Remember, when it comes to pool maintenance, a little bit of work everyday will save you A LOT of work one day.

This Article is written by Alice Bradley, Native content editor

18 Aug 2017

Originally published Published on Link

34 views0 comments


bottom of page